Corona lite installation problem

[Inam]

Hi,
I am new to linux, trying to install corona lite 4.2.2 on Fedora 15. My system fulfills all the hardware requirememnts mentioned in the documentation file. I tried to install the package, but was unable to do it. Searched a lot of forums, installed latest versions of perl and GCC. Still i get the below mentioned error./////

[Dam@Dam Corona_Lite_4.2.2]$ make install PREFIX=/home/Dam/Downloads/trial1/Corona_Lite_4.2.2
make -C pairing install PREFIX=/home/Dam/Downloads/trial1/Corona_Lite_4.2.2
make[1]: Entering directory `/home/Dam/Downloads/trial1/Corona_Lite_4.2.2/pairing'
*** Bootstrapping Perl project perl/Makefile
cd perl && DISCOVERSION='' perl Makefile.PL PREFIX=/home/Dam/Downloads/trial1/Corona_Lite_4.2.2 DESTDIR='' LIB='/home/Dam/Downloads/trial1/Corona_Lite_4.2.2/lib/perl'
Can't locate ExtUtils/MakeMaker.pm in @INC (@INC contains: inc /usr/local/lib/perl5 /usr/local/share/perl5 /usr/lib/perl5/vendor_perl /usr/share/perl5/vendor_perl /usr/lib/perl5 /usr/share/perl5 .) at inc/Module/Install/Can.pm line 9.
BEGIN failed--compilation aborted at inc/Module/Install/Can.pm line 9.
Compilation failed in require at inc/Module/Install.pm line 261.
Can't locate ExtUtils/MakeMaker.pm in @INC (@INC contains: inc /usr/local/lib/perl5 /usr/local/share/perl5 /usr/lib/perl5/vendor_perl /usr/share/perl5/vendor_perl /usr/lib/perl5 /usr/share/perl5 .) at inc/Module/Install/Makefile.pm line 5.
BEGIN failed--compilation aborted at inc/Module/Install/Makefile.pm line 5.
Compilation failed in require at inc/Module/Install.pm line 261.
The 'makemaker_args' method does not exist in the 'inc' path!
Please remove the 'inc' directory and run Makefile.PL again to load it.
make[1]: *** [perl/Makefile] Error 255
make[1]: Leaving directory `/home/Dam/Downloads/trial1/Corona_Lite_4.2.2/pairing'
make: *** [pairing-install] Error 2

///////
Help me out guys

[westerman]

Do you have Perl's MakeMaker installed? It is part of the core utilities but never-the-less you may need to do an install. Do a simple:

perl -e 'use ExtUtils::MakeMaker'

If it returns without errors then you do have MakeMaker installed and I am not sure why you are getting the Corona error.

If it returns with errors then you will need to install MakeMaker. In this case since you said you have the latest Perl installed then you may need to get a local Perl guru (or Linux guru) to help you out.

[Inam]

Thanks Westerman, MakeMaker was missing, installed it by:
yum install perl-ExtUtils-MakeMaker

No errors seen when i used:
perl -e 'use ExtUtils::MakeMaker'

Installation complete, no errors
Thanks again.