Unconfigured Ad

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • lihairi
    Junior Member
    • Oct 2009
    • 5

    #1

    question about RNA-seq

    Hi everyone,

    I have a question about RNA-seq.

    "Some manipulations during library construction also complicate the analysis
    of RNA-Seq results. For example, many shorts reads that are identical to each
    other can be obtained from cDNA libraries that have been amplified. These could be a genuine reflection of abundant RNA species, or they could be PCR artefacts. One way to discriminate between these possibilities is to determine whether the same sequences are observed in different biological replicates.(Nat Rev Genet. 2009 Jan;10(1):57-63)"

    Is there any other way in the above situation to discriminate between a genuine reflection of abundant RNA or PCR artefacts?

    Thanks,

    Hai-Ri Li
  • simonandrews
    Simon Andrews
    • May 2009
    • 870

    #2
    If your library has been randomly fragmented then it should be possible to look for fragments which appear way more frequently than would be expected by chance. In even a short mRNA you should have a range of different possible fragments and if this is an abundant transcript most or all of these should appear more frequently. PCR artefacts usually affect only a small subset of all possible fragments and would produce a very uneven distribution of fragments over the transcript.

    Comment

    • lihairi
      Junior Member
      • Oct 2009
      • 5

      #3
      Thank you for interpretation. You mean we can ignore PCR artefacts because they affect only a small subsets of fragments and it will not affect final analysis results. However, sometimes we found so many tags hit the same positions so that we cannot ingore them.

      Again, is there any other way in the above situation to discriminate between a genuine reflection of abundant RNA or PCR artefacts?

      Thanks,

      Hai-Ri Li

      Comment

      • simonandrews
        Simon Andrews
        • May 2009
        • 870

        #4
        Originally posted by lihairi View Post
        You mean we can ignore PCR artefacts because they affect only a small subsets of fragments and it will not affect final analysis results.
        No, that's not what I'm saying. What I was trying to say was that you can normally distinguish PCR artefacts from expression changes because expression changes normally involved the even enrichment of a large number of different fragments over the expressed region, whereas PCR artefacts usually take only a small number of fragments and amplify them to an unnatural degree when viewed in the context of the surrounding fragments.

        We usually filter our data by measuring the percentage of reads in a region which come from exact overlaps. If this value is above 5-10% then we reject it as a likely PCR artefact. I'm intending to move this to an observed/expected calculation though as this is less prone to errors in very short regions with high coverage.

        Comment

        • lihairi
          Junior Member
          • Oct 2009
          • 5

          #5
          Last time you mentioned "We usually filter our data by measuring the percentage of reads in a region which come from exact overlaps". Here region must mean a window, 100 base? 200 base?

          How to do observed/expected calculation?

          Thanks.

          Comment

          • simonandrews
            Simon Andrews
            • May 2009
            • 870

            #6
            Originally posted by lihairi View Post
            Last time you mentioned "We usually filter our data by measuring the percentage of reads in a region which come from exact overlaps". Here region must mean a window, 100 base? 200 base?
            In our case region is pretty generic - sometimes we use fixed size windows (with a size which depends normally on our data density), in other cases we construct contigs from sets of overlapping reads, or we might design probes over particular classes of annotation feature (genes, exons, microRNAs, whatever). These things change depending on what kind of experiment you're running.


            Originally posted by lihairi View Post
            How to do observed/expected calculation?
            We're actually not using a proper O/E calculation at the moment (though it would be nice to move to that). Our filter calculates what percentage of reads which overlap a particular region come from exact overlaps, with the same start and end position. For randomly placed reads this value is usually very low (below 5%), but in some cases you will see towers of exactly duplicated reads which usually indicate a mapping or PCR problem, and we filter these out. You can also get high values from low absolute numbers of reads, so you either need to account for this, or ignore it if you're going to filter those regions anyway.

            I hope that makes things a bit clearer.

            Comment

            • lihairi
              Junior Member
              • Oct 2009
              • 5

              #7
              Recently I downloaded a lot of RNA-seq data from NCBI and mapped to Reference RNA using eland_25. I found around 30-40% of tags were mapped to the exactly same postions as others (even though removing the effect of RNA isorforms), much higher than 5%. I do not know how to interpretate this results.

              Comment

              Latest Articles

              Collapse

              • SEQadmin2
                Multiomic Liquid Biopsy: What DNA/RNA Panels Reveal That DNA Alone Can’t
                by SEQadmin2



                Tumors contain complex mixtures of cell populations that evolve in response to treatment and host-specific factors. Tissue biopsies provide only static snapshots of a tumor’s state. But what if we could follow that evolution over time using a minimally invasive technique?

                Liquid biopsies can detect tumor-derived material circulating in the bloodstream, providing a way to study treatment response, detect emerging resistance, and discover new biomarkers. Circulating
                ...
                10-14-2026, 09:55 AM
              • SEQadmin2
                New Genomics Technologies Take Aim at Long-Standing Limits
                by SEQadmin2


                Researchers using sequencing and genomics tools often have to make trade-offs. They can choose between speed or scale, short reads or long-range information, or targeted panels or a view of the whole transcriptome. New technologies that have been released this year are built to address those tough choices.

                We asked six companies the same four questions to learn about their latest products. The new technologies bring a lot to the table, including rethinking sequencing
                ...
                09-28-2026, 10:25 AM

              ad_right_rmr

              Collapse

              News

              Collapse

              Topics Statistics Last Post
              Started by SEQadmin2, 10-22-2026, 11:13 AM
              0 responses
              22 views
              0 reactions
              Last Post SEQadmin2  
              Started by SEQadmin2, 10-22-2026, 10:48 AM
              0 responses
              19 views
              0 reactions
              Last Post SEQadmin2  
              Started by SEQadmin2, 10-15-2026, 10:52 AM
              0 responses
              36 views
              0 reactions
              Last Post SEQadmin2  
              Started by SEQadmin2, 10-14-2026, 05:39 AM
              0 responses
              42 views
              0 reactions
              Last Post SEQadmin2  
              Working...