Dear seqanswers community!
I have been trying to remove a long adapter sequence from my paired-end reads wtih cutadapt version 1.8.1 which should support simulteneous trimming of reads from different directions, but I keep getting message
error: too many parameters.
Does anybody have any suggestions why do I get this message?
I followed up the standard command script
cutadapt -a ADAPTER_FWD -A ADAPTER_REV -o out.1.fastq -p out.2.fastq reads.1.fastq reads.2.fastq
Regards,
Krista
I have been trying to remove a long adapter sequence from my paired-end reads wtih cutadapt version 1.8.1 which should support simulteneous trimming of reads from different directions, but I keep getting message
error: too many parameters.
Does anybody have any suggestions why do I get this message?
I followed up the standard command script
cutadapt -a ADAPTER_FWD -A ADAPTER_REV -o out.1.fastq -p out.2.fastq reads.1.fastq reads.2.fastq
Regards,
Krista