In case it helps anyone else, to install the Roche 454 sequence analysis software (gsAssembler or newbler, gsMapper, etc.) on a computer running 64 bit Fedora 15, there were a few libraries that needed to be installed first, but a necessary condition to get this to work for me was to first enable both the "updates" and "updates-testing" repositories. This is done using
Applications → System Tools → Add/Remove Software → System → Software Sources → Software Sources
Then, this command installed the necessary libraries, along with a number of dependencies:
The install then went smoothly.
However, the "454 Sequencing Applications" menu did not appear in the main Applications menu. To make them show up (and I am operating in Gnome 3's "Fallback mode" if that makes a difference), I also needed this command
For reference, here is the error I received before enabling all repositories:
Applications → System Tools → Add/Remove Software → System → Software Sources → Software Sources
Then, this command installed the necessary libraries, along with a number of dependencies:
Code:
sudo yum install zlib.i686 libXi.i686 libXtst.i686 libXaw.i686
However, the "454 Sequencing Applications" menu did not appear in the main Applications menu. To make them show up (and I am operating in Gnome 3's "Fallback mode" if that makes a difference), I also needed this command
Code:
sudo ln -s /etc/xdg/menus/applications-merged /etc/xdg/menus/applications-gnome-merged
Code:
Error: Protected multilib versions: libgcc-4.6.0-10.fc15.i686 != libgcc-4.6.1-9.fc15.x86_64
Comment